A bevel setting board and height gauge one one side, 12" rule and center finding rule on other side.
The bevel setting board is designed for easy and precise setting or reading of a sliding bevel. Simply position your sliding bevel against the edge of the bevel setting board and set it to the desired angle. To find out what angle a piece has, just measure it with your bevel then slide the bevel up and down the bevel board until you get an exact match.
The bevel setting board has generous spacing between its sharp, black etched lines and numbers. It has distinct ½ degree marks and ¼ degree dots for easy reading. Hardened stainless steel with satin chrome finish.
Can also be used in other ways including setting bandsaw bevel, angled drilling, drawing parallel and square lines, and in router table, shaper and table saw setups.